Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Closure Assist Mechanisms and Hinges

Tesla Model 3 2017-2026 Service Manual / Closures / Closure Assist Mechanisms and Hinges

READ NEXT:

 Gas Strut - Hood - LH (Remove and Replace)

Remove Open the hood. Use a prop to attach the hood assembly in the open position. Release the clip that attaches the hood gas strut to the hood mount. Release the clip that attaches t

 Gas Strut - Trunk - LH (Remove and Replace)

Remove Open the trunk, and support the trunk in the open position. Release the clip that attaches the lower end of the LH trunk gas strut to the hinge on the vehicle. Release the cl

 Hinge - Hood - LH (Remove and Replace)

Remove Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). Remove the hood latch co

SEE MORE:

 Actuator - Bleed - LH (Remove and Replace)

Remove Remove the cross car beam. See Beam - Cross Car (Remove and Replace). Disconnect the electrical wiring harness connector from the LH bleed actuator. Remove the bolts that attach the actuator to the HVAC module, and then remove the actuator from the module. Torque 2.3 Nm

 Rear Cameras

Camera - Rear Facing (Remove and Replace) Remove Remove the trunk trim. See Trim - Lid - Trunk (Remove and Replace). Remove the trunk exterior release switch. See Switch - Exterior Release - Trunk (Remove and Replace) Install Install the trunk exterior release switch. See Switch - Exterior

© 2019-2026 Copyright www.tmodel3.com