Tesla Model 3: Hose - Return - Powertrain (Remove and Replace)
Remove
- Remove the HV battery. See HV Battery (RWD) (Remove and Install).
.png)
- Release the clips (x5) that attach the powertrain return (lower) hose to
the RH side of the HV battery, and remove the hose from the HV battery.
- Remove the plugs from the powertrain return hose, if installed.
Install
Installation procedure is the reverse of removal.
READ NEXT:
Remove
Remove the HV battery. See HV Battery (RWD) (Remove and Install).
Release the clip and disconnect the powertrain supply hose fitting from
the RH underside of the penthouse.
Releas
Remove
Remove the cooling fan module. See Module - Cooling Fan (Remove and
Install).
Release the clips that attach the active grille shutter to the cooling
fan module, and then remove t
Superbottle (Dual Motor) - Remove
SPECIAL TOOLS
Kit, Svc Plug, Cooling Hose, Model 3 (1135762-00-A)
Remove
Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd
Row (Remove and R
SEE MORE:
Remove
Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
Disconnect the electrical wiring harness connector from the LH rear fog/reverse
light.
Remove the nut that attaches the LH rear fog/reverse light to the trunk
lid.
Torque 3.2 Nm
Remove the LH rea
Remove
Remove both the LH and RH air wave end caps. See
End Cap - Air Wave - LH (Remove and Replace).
Release the clips that attach the main instrument panel decor trim, and
then remove the trim from the instrument panel.
Install
Installation procedure is the reverse of removal, exc