Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Hose - Supply - Powertrain (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Thermal Management / Cooling System / Hose - Supply - Powertrain (Remove and Replace)

Remove

  1. Remove the HV battery. See HV Battery (RWD) (Remove and Install).

Hose - Supply - Powertrain (Remove and Replace)

  1. Release the clip and disconnect the powertrain supply hose fitting from the RH underside of the penthouse.

Hose - Supply - Powertrain (Remove and Replace)

  1. Release the clips (x5) that attach the powertrain supply (upper) hose to the RH side of the HV battery, and remove the hose from the HV battery.
  2. Remove the plug from the powertrain supply hose, if installed.

Install

Installation procedure is the reverse of removal.

    READ NEXT:

     Radiator (Remove and Replace)

    Remove Remove the cooling fan module. See Module - Cooling Fan (Remove and Install). Release the clips that attach the active grille shutter to the cooling fan module, and then remove t

     Superbottle (Dual Motor) (Remove and Replace)

    Superbottle (Dual Motor) - Remove SPECIAL TOOLS Kit, Svc Plug, Cooling Hose, Model 3 (1135762-00-A) Remove Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and R

    SEE MORE:

     Buckle - 2nd Row - Center (Remove and Replace)

    Note: This procedure was formulated using a release candidate or production model. Follow safety requirements and use extreme caution when working on or near high-voltage systems and components. SPECIAL TOOLS Tool, Inductive Heating (1032900-00-A) Remove Remove the 2nd row seat cushion. See Sea

     Panel - Aero Shield - Mid (Remove and Replace)

    Remove Raise and support the vehicle. See Raise Vehicle - 2 Post Lift. Remove the bolts (x13) that attach the mid aero shield panel to the vehicle, and then remove the panel from the vehicle. Install Apply a thin bead of Loctite 222 to the threads of the bolts (x13) that atta

    © 2019-2026 Copyright www.tmodel3.com