Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Link - Fore - Lower - Rear - LH - Remove

Tesla Model 3 2017-2023 Service Manual / Suspension / Rear Suspension (Including Hubs) / Link - Fore - Lower - Rear - LH (Remove and Replace) / Link - Fore - Lower - Rear - LH - Remove

 Link - Fore - Lower - Rear - LH (Remove and Replace)

SPECIAL TOOLS

Tool, Spring Compressor, Hook, Model 3 (1135103-00-A)

 Remove
  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH rear wheel. See Wheel (Remove and Install).
  3. Remove the LH rear wheel arch liner. See Wheel Arch Liner - Rear - LH (Remove and Replace).
  4. Remove the mid aero shield panel. See Panel - Aero Shield - Mid (Remove and Replace).
  5. Place support stand underneath the middle of the rear subframe.

  Link - Fore - Lower - Rear - LH - Remove

  1. Remove the bolt and nut that attach the LH rear lower fore link to the knuckle.

  Link - Fore - Lower - Rear - LH - Remove

  1. Remove the clips that attach the coolant hose to the LH shear plate.

  Link - Fore - Lower - Rear - LH - Remove

  1. Remove the smaller bolts that attach the LH shear plate to the HV battery.

  Link - Fore - Lower - Rear - LH - Remove

  1. Loosen the large bolt that attaches the LH shear plate and subframe to the body, and then rotate the shear plate aside.

  Link - Fore - Lower - Rear - LH - Remove

  1. Remove the bolt that attaches the LH rear lower fore link to the subframe.
  2. Remove the LH rear lower fore link from the vehicle.

    READ NEXT:

     Link - Fore - Lower - Rear - LH - Install

    Install   Install the LH rear lower fore link to the subframe, and then hand-tighten the bolt t

     Link - Fore - Upper - Rear - LH (Remove and Replace)

    SPECIAL TOOLS Tool, Spring Compressor, Hook, Model 3 (1135103-00-A) Remove Remove the rear subframe assembly. See Subframe Assembly - Rear (Remove and Install). Remove the bolt and nut that

     Stabilizer Bar - Rear (Remove and Replace)

      Remove Raise and support the vehicle. See Raise Vehicle - 2 Post Lift. Remove the mid aero shield panel. See Panel - Aero Shield - Mid (Remove and Replace).

    SEE MORE:

     Brake Rotor - Rear - LH (Remove and Replace)

    SPECIAL TOOLS Tool, Caliper Spreader, Model 3 (1134786-00-A) Remove Raise the vehicle and remove the LH rear wheel. See Wheel (Remove and Install). Use Toolbox to place the vehicle into EPB Service Mode. See Release Parking Brake Using Toolbox Disconnect the electrical wiring harness con

     Hose - Chiller to Car Computer and HV Battery Supply Manifold (Dual Motor) (Remove and Replace)

    SPECIAL TOOLS Plug,Car Computer Fluid Port (1119171-00-A) Kit, Svc Plug, Cooling Hose, Model 3 (1135762-00-A) Remove Remove the front subframe assembly. See Subframe Assembly - Front (Dual Motor) (Remove and Install). Disconnect the electrical harness from the chiller and EXV assembly hos

    © 2019-2023 Copyright www.tmodel3.com