Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Module - TPMS (Sensor ID Learn)

Tesla Model 3 2017-2026 Service Manual / Wheel and Tires / Tire Pressure Monitoring System (TPMS) / Module - TPMS (Sensor ID Learn)

SPECIAL TOOLS

TOOL, TPMS SERVICE, ATEQ VT30 (1050759-00-A)
TOOL, TPMS SERVICE, ATEQ VT30 (1050759-00-A)

TOOL, TPMS SERVICE, ATEQ VT36 (1050759-00-B)
TOOL, TPMS SERVICE, ATEQ VT36 (1050759-00-B)

Procedure

  1. Review the TPMS service tool profile.
  2. Use the TPMS service tool to read and record the wheel sensors in the order displayed on the tool's screen.
  3. In Toolbox 3, run the "PROC_TPMS_X_TPMS-SENSOR-LEARN" Action, and then update the TPMS sensor IDs with the values from the TPMS service tool.
  4. Test drive the vehicle to at least 15 mph for a short distance to reset the TPMS alert.

    READ NEXT:

     Sensor - TPMS (Remove and Replace)

        Remove Remove the wheel. See Wheel (Remove and Install). Place the wheel on

     Front Drive Unit

     Front Drive Unit Assembly

    SEE MORE:

     Knuckle - Suspension - Front - LH (RWD) (Remove and Replace)

    Remove Remove the LH front brake dust shield. See Shield - Dust - Brake - Front - LH (Remove and Replace). Remove the bolts that attach the LH front ABS wheel speed sensor electrical harness to the LH front suspension knuckle. Torque 5 Nm Release the clip that attaches the LH f

     Panel - Air Vent - Center Console (Remove and Replace)

    Remove Move the driver seat and front passenger seat forward. Release the clips (x4) that attach the center console air vent panel to the center console, and separate the panel from the console. Disconnect the electrical harness from the center console rear USB hub connector,

    © 2019-2026 Copyright www.tmodel3.com