Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Seal - Glass Run - Front Door - LH (Remove and Replace)-  Install

Install

Seal - Glass Run - Front Door - LH (Remove and Replace)-  Install

  1. Position the new LH front door glass run seal on the LH front door.

 Tip: If necessary, apply a small amount of P80 lubricant on the length of the seal to aid installation.

Seal - Glass Run - Front Door - LH (Remove and Replace)-  Install

  1. Position the LH door mirror on the LH front door, and then install the clip that attaches the mirror electrical harness to the door.

Seal - Glass Run - Front Door - LH (Remove and Replace)-  Install

  1. Install the bolts that attach the LH door mirror to the LH front door.  Torque 15 Nm

Caution:

Use only hand tools to remove or install the fasteners. Do not use impact or power tools.

Seal - Glass Run - Front Door - LH (Remove and Replace)-  Install

  1. Install the clips that attach the LH front door glass run seal to the LH front door.

Seal - Glass Run - Front Door - LH (Remove and Replace)-  Install

  1. Connect the mirror electrical harness to the connectors on the LH front door.
  2. Install the LH front door inner belt seal. See Seal - Inner Belt - Front Door - LH (Remove and Replace).
  3. Install the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).

    READ NEXT:

     Seal - Hood (Remove and Replace)

    Remove Open the hood. Release the seal from the underhood storage unit, and then remove the seal from the underhood storage unit. Install Installation procedure is the reverse of remov

     Seal - Inner Belt - Front Door - LH (Remove and Replace)

    Remove Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace). Remove the rear of the inner belt seal from the door. Release the rest of the seal fro

     Seal - Inner Belt - Rear Door - LH (Remove and Replace)

    Remove Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install). Release the clips that attach the rear and front pieces of the inner belt seal to the r

    SEE MORE:

     Spoiler - Rear (Retrofit using Jig)

    SPECIAL TOOLS Kit, Spoiler Alignment, M3 (1479070-00-A ) Procedure Clean the installation surface of the spoiler with isopropyl alcohol (IPA) wipes, and allow it to dry before continuing. Note: Clean any moisture or contaminates that might be present from rain or vehicle washing, otherwise

     Rear Console

    Your Model 3 has a rear console integrated in the center of the second row seat back. Pull the console down to access the rear cup holders, or use it as an armrest. Coat Hangers Your Model 3 has a coat hanger on each side of the vehicle in the second row. Push the coat hanger to release i

    © 2019-2024 Copyright www.tmodel3.com