Tesla Model 3: Seal - Inner Belt - Rear Door - LH (Remove and Replace)
Tesla Model 3 2017-2026 Service Manual / Closures / Seals Body Closures / Seal - Inner Belt - Rear Door - LH (Remove and Replace)
Remove
- Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).
- Release the clips that attach the rear and front pieces of the inner belt seal to the rear door, and then remove the rear and front pieces of the inner belt seal.
- Slowly peel the length of the strip piece of the seal from the rear
door.
READ NEXT:
Seal - Outer Belt - Front Door - LH (Remove and Replace)
Remove
Remove the LH front door trim panel. See
Panel - Door Trim - Front - LH (Remove and Install).
Pull up to release the seal that attaches the LH front door outer belt
seal to the fr
Seal - Outer Belt - Rear Door - LH (Remove and Replace)
Note:
This procedure was formulated using a release candidate or production
model. Follow safety requirements and use extreme caution when working on or
near high-voltage systems and components.
Seal - Secondary - Front Door - LH (Remove and Replace)
Remove
Open the LH front door.
Use narrow-width tape to carefully mark the location of the secondary
seal around the door.
Caution:
Make sure that the edge of the tape accurately follows the
SEE MORE:
Charge Port Voltage Check
Procedure (Single - Phase)
SPECIAL TOOLS
Insulation Multimeter, Fluke 1507 (NA)
(1076921-00-B)
Insulation Multimeter, Fluke 1587 (EMEA)
(1076921-00-A)
Windshield (Remove and Replace)
Windshield (Remove and Replace) - Remove
Remove
Remove the cowl screen panel. See Panel - Cowl Screen (Remove and
Replace).
Disconnect the electrical harness from the windshield heater connector.
Partially close the hood.
Caution:
Use care not to damage the dashboard.
Place a fende
© 2019-2026 Copyright www.tmodel3.com
