Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Striker - Seat Back - 2nd Row - RH (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Seats / 2nd Row Seat Assemblies and Hardware / Striker - Seat Back - 2nd Row - RH (Remove and Replace)

Striker - Seat Back - 2nd Row - RH (Remove and Replace)

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the LH and RH 2nd row seat side bolsters. See Bolster - Side - Seat - 2nd Row - LH (Remove and Replace).
  3. Remove the LH side rail trim. See Trim - Side Rail - LH (Remove and Replace).
  4. Remove the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  5. Remove the RH side rail trim. See Trim - Side Rail - LH (Remove and Replace).
  6. Remove the RH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).

Striker - Seat Back - 2nd Row - RH (Remove and Replace)

  1. Release the clips (x4) that attach the front of the package tray to the body.
  2. Pull the package tray forward, and then lift up the package tray to access the seat back striker.

Note: Support the package tray in the raised position.

Striker - Seat Back - 2nd Row - RH (Remove and Replace)

  1. Remove the bolts that attach the 2nd row RH seat back striker to the body, and then remove the striker from the vehicle.   Torque 16 Nm

Install

Installation procedure is the reverse of removal.

    READ NEXT:

     Front Seat Covers Pads and Trims

     Cover - Outer Side - Driver Seat (Remove and Install)

    SPECIAL TOOLS Key, Seat Belt Release, Model 3 (1133787-00-A) Remove Open the LH front door. Move the driver's seat fully forward, and adjust the seat cushion height to maximum. Caution: Do n

     Foam - Backrest - Driver Seat (Remove and Replace)

    Foam - Backrest - Driver Seat (Remove and Replace) - Remove Remove Remove the driver seat. See Seat - Driver (Remove and Replace). Remove the driver headrest trim. See Trim - Headrest - Driver

    SEE MORE:

     Fascia - Front (Remove and Replace)

    Fascia - Front (Remove) Remove Remove the front license plate bracket. Remove the front fascia. Disconnect the electrical harness from the RH front turn signal/fog light connector. Release the clips that attach the electrical harness to the front turn signal/fog light. Remove

     Motor - Seat Tilt - Driver Seat (Remove and Replace)

    Remove Remove the driver seat. See Seat - Driver (Remove and Replace). Remove the driver seat outer side cover. See Cover - Outer Side - Driver Seat (Remove and Install). Disconnect the electrical harness from the driver seat tilt motor connector. Remove the bolts that attach t

    © 2019-2026 Copyright www.tmodel3.com