Tesla Model 3: Seats
- Front Seat Tracks and Motors
- Cover - Front - Seat Track - 1st Row Seat (Remove and Replace)
- Cover - Rear - Seat Track - 1st Row Seat (Remove and Replace)
- Motor - Recliner - Backrest - Driver Seat (Remove and Replace)
- Motor - Seat Height - Driver Seat (Remove and Replace)
- Motor - Seat Tilt - Driver Seat (Remove and Replace)
- Switch - Back Rest and Cushion Adjust - Driver Seat (Remove and Replace)
- Front Seat Assemblies and Hardware
- Lumbar Support - Backrest - Driver Seat (Remove and Replace)
- Shell - Seat Back - Driver (Remove and Replace)
- Seat - Driver (Remove and Replace)
- Trim - Headrest - Driver (Remove and Replace)
- 2nd Row Seat Assemblies and Hardware
- Armrest - 2nd Row (Remove and Replace)
- Bezel - Handle - Seat Back - 2nd Row - LH (Remove and Replace)
- Bolster - Side - Seat - 2nd Row - LH (Remove and Replace)
- Bracket - Hinge - Seat Back - 2nd Row - LH (Remove and Replace)
- Cap - Penthouse 12V (Remove and Replace)
- Cap - Penthouse HV (Remove and Replace)
- Closeout - Armrest - 2nd Row (Remove and Replace)
- Frame - Seat Back - 2nd Row - LH (Remove and Replace)
- Handle - Seat Back - 2nd Row - LH (Remove and Replace)
- Headrest - 2nd Row - Center (Remove and Replace)
- Latch - Seat Back - 2nd Row - LH (Remove and Replace)
- Pivot Sleeve - Seat Back - 2nd Row - LH (Remove and Replace)
- Rail - 2nd Row - Inner - LH (Remove and Replace)
- Rail - 2nd Row - Outer - LH (Remove and Replace)
- Seat Back - 2nd Row - LH (Remove and Install)
- Seat Back - 2nd Row - RH (Remove and Install)
- Seat Cushion - Lower - 2nd Row (Remove and Replace)
- Striker - Seat Back - 2nd Row - LH (Remove and Replace)
- Striker - Seat Back - 2nd Row - RH (Remove and Replace)
- Front Seat Covers Pads and Trims
- Cover - Outer Side - Driver Seat (Remove and Install)
- Foam - Backrest - Driver Seat (Remove and Replace)
- Foam - Cushion - Driver Seat (Remove and Replace)
- 2nd Row Seat Covers Pads and Trims
READ NEXT:
Cover - Front - Seat Track - 1st Row Seat (Remove and Replace)
Remove
Move the seat fully rearward.
Release the clips at the rear of the seat track front cover that attach
the cover to the seat track, and then slide the cover forward off the track.
Ins
Cover - Rear - Seat Track - 1st Row Seat (Remove and Replace)
Correction code 13011822
Remove
Move the seat fully forward.
Release the clips at the front of the seat track rear cover that attach
the cover to the seat track, and then slide the cover rea
SEE MORE:
Motor Assembly - Rear (Remove and Replace)
Remove
Remove the rear drive unit. See Drive Unit - Rear
(Remove and Replace).
Remove the rear drive unit inverter. See Inverter -
Rear Drive Unit (Remove and Install).
Position
Forward Facing (Target Calibration)
SPECIAL TOOLS
Camera Calibration Target (1053066-00-A)
Wrench, 2.5mm, Thin (1448868-00-A)
Note: This procedure describes how to calibrate the forward
facing cameras. It does not apply to the rear facing camera.
Setup
Park the vehicle on a flat surface with at least 106 cm (3.5 ft) of
space in
© 2019-2026 Copyright www.tmodel3.com
