Tesla Model 3: 2nd Row Seat Covers Pads and Trims
Tesla Model 3 2017-2026 Service Manual / Seats / 2nd Row Seat Covers Pads and Trims
READ NEXT:
Cover - Seat Back - 2nd Row Seat - RH (Remove and Replace)
Remove
Remove the 2nd row lower seat cushion. See
Seat Cushion - Lower - 2nd Row (Remove and Replace).
Remove the RH 2nd row seat side bolster. See
Bolster - Side - Seat - 2nd Row - LH (Remove an
Cup Holder - 2nd Row (Remove and Replace)
Remove
Open the RH rear door.
Fold down the armrest.
Use a plastic trim tool to release the cup holder from the locking tabs.
Lift up on the cup holder and remove it from the vehicle
SEE MORE:
Ankle Catcher (Remove and Replace)
Remove
Remove the front fascia.
Remove the bolts that attach the bottom of the cooling fan module to the
ankle catcher
Note: Lift the condenser fan module up to ease removal of the bolts.
Loosen but do not remove the bolts that attach the upper section of the
front end carrier to
Striker - Trunk (Remove and Replace)
Remove
Remove the rear trunk sill trim. See Trim - Sill - Trunk (Remove and
Replace).
Use masking tape to mark the location of the trunk striker.
Remove the bolts that attach the trunk striker to the body, and then
remove the striker from the vehicle.
Install
Align the trunk
© 2019-2026 Copyright www.tmodel3.com
