Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Instrument Panel

Tesla Model 3 2017-2026 Service Manual / Instrument Panel

READ NEXT:

 Beam - Cross Car (Remove and Replace)

 Beam - Cross Car (Remove and Replace) - Remove

Remove Remove the IP carrier. See IP Carrier (Remove and Install). Remove the LH air wave duct. See Duct - Air Wave - LH (Remove and Replace). Remove the LH footwell duct. See Duct - Footwel

 Beam - Cross Car (Remove and Replace) - Install

Install With an assistant, position the cross car beam in the vehicle for installation. Caution: Do not damage the interior when installing the cross car beam in the vehicle. Hand-tighten

SEE MORE:

 Subframe Assembly - Rear - Remove

SPECIAL TOOLS Fixture, Subframe, Model 3 (1099645-00-B) Lifting Sling, Drive Unit, Model 3 (NA, APAC) (1130279-00-A) Adapter, Subframe, Body Shop, Model 3 (1130481-00-A) Tool, Hub Puller, Hydraulic (1096075-00-A) Tool, Axle Extraction, Model 3 (1133386-00-A) Lever Lock, HV Connector, Model 3 (1140

 Cap - Penthouse 12V (Remove and Replace)

Remove Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace) Lift the 12V cap straight up from over the high voltage controller connector on the RH side of the penthouse, and then remove the 12V cap from the vehicle. Install Installation procedu

© 2019-2026 Copyright www.tmodel3.com