Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Beam - Cross Car (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Instrument Panel / Beam - Cross Car (Remove and Replace)

READ NEXT:

 Beam - Cross Car (Remove and Replace) - Remove

Remove Remove the IP carrier. See IP Carrier (Remove and Install). Remove the LH air wave duct. See Duct - Air Wave - LH (Remove and Replace). Remove the LH footwell duct. See Duct - Footwel

 Beam - Cross Car (Remove and Replace) - Install

Install With an assistant, position the cross car beam in the vehicle for installation. Caution: Do not damage the interior when installing the cross car beam in the vehicle. Hand-tighten

 Cover - Airbag - Knee - Driver (Remove and Replace)

Note: This procedure was formulated using a release candidate or production model. Follow safety requirements and use extreme caution when working on or near high-voltage systems and components.

SEE MORE:

 HV Battery (Dual Motor) (Remove and Install)

HV Battery (Dual Motor) - Remove SPECIAL TOOLSAdapter, Lift Pad, Model 3 (1453419-00-A)Key, Seat Belt Release, Model 3 (1133787-00-A) ASY, Battery Table, Manual Lift (1020566-00-F)Top Plate, Battery Table, Manual Lift (1020566-99-A) Hoist, H-Frame EMEA (1129166-00-A)Kit, Alignment

 Sun Visor - Driver (Remove and Replace)

Remove Remove the fastener that attaches the driver sun visor to the vehicle. Torque 6 Nm Disconnect the electrical connector from the driver sun visor. Remove the driver sun visor from the vehicle. Install Installation procedure is the reverse of removal.

© 2019-2026 Copyright www.tmodel3.com