Tesla Model 3: Front Seat Tracks and Motors
Tesla Model 3 2017-2026 Service Manual / Seats / Front Seat Tracks and Motors
- Cover - Front - Seat Track - 1st Row Seat (Remove and Replace)
- Cover - Rear - Seat Track - 1st Row Seat (Remove and Replace)
- Motor - Recliner - Backrest - Driver Seat (Remove and Replace)
- Motor - Seat Height - Driver Seat (Remove and Replace)
- Motor - Seat Tilt - Driver Seat (Remove and Replace)
- Switch - Back Rest and Cushion Adjust - Driver Seat (Remove and Replace)
READ NEXT:
Cover - Front - Seat Track - 1st Row Seat (Remove and Replace)
Remove
Move the seat fully rearward.
Release the clips at the rear of the seat track front cover that attach
the cover to the seat track, and then slide the cover forward off the track.
Ins
Cover - Rear - Seat Track - 1st Row Seat (Remove and Replace)
Correction code 13011822
Remove
Move the seat fully forward.
Release the clips at the front of the seat track rear cover that attach
the cover to the seat track, and then slide the cover rea
Motor - Recliner - Backrest - Driver Seat (Remove and Replace)
Remove
Remove the lumbar support assembly from the driver's seat back. See
Lumbar Support - Backrest - Driver Seat (Remove and Replace).
Remove and discard the clip that attaches the recli
SEE MORE:
Fluid Reservoirs
Removing the Maintenance Panel
To check fluid levels, remove the maintenance
panel:
Open the hood.
Pull the maintenance panel upward to
release the clips that hold it in place.
If checking the Battery coolant, remove
the cabin intake trim panel by pulling it
upwards to r
Sensor - Temperature - Evaporator (Remove and Replace)
Remove
Remove the driver floormat.
Remove the LH center console side panel carpet. See
Carpet - Side Panel - Center Console - LH (Remove and Replace).
Disconnect the evaporator temperature sensor electrical connector.
Release the tabs that attach the evaporator temperature sensor ins
© 2019-2026 Copyright www.tmodel3.com
