Tesla Model 3 Owners & Service Manuals

Tesla Model 3: 2nd Row Seat Assemblies and Hardware

Tesla Model 3 2017-2026 Service Manual / Seats / 2nd Row Seat Assemblies and Hardware

READ NEXT:

 Armrest - 2nd Row (Remove and Replace)

Remove Open all four doors and move the front LH and RH seats fully forward. Fold down the RH 2nd row seatback assembly. Remove the bolt that attaches the 2nd row armrest to the LH 2nd row

 Bezel - Handle - Seat Back - 2nd Row - LH (Remove and Replace)

Remove Release the LH 2nd row seat back and fold it slightly forward. Use a pry tool to release the clips (x2) that attach the LH 2nd row seat back handle bezel to the LH 2nd row seat back h

 Bolster - Side - Seat - 2nd Row - LH (Remove and Replace)

Remove Fold down the LH 2nd row seat. Pull the 2nd row side bolster inward, and then move the bolster up to remove from the vehicle. Remove and discard the bolster plastic bracket from t

SEE MORE:

 Light - Fog - Front (Adjust)

Procedure Special tools required for this procedure: SPECIAL TOOLS Pliers, Clip Removal (1133569-00-A) On a wall, measure 14.5 in (36.8 cm) from the floor, and then apply a length of 1-inch masking tape horizontally to the wall to mark the measurement. Measure 25 ft (7.62 m) from the wall,

 Harness - Penthouse - HV Battery (Remove and Replace)

Harness - Penthouse - HV Battery- Remove SPECIAL TOOLS Ratchet, 1/4" Sq Dr, HV Insulated (1057602-00-A) Ext Bar, Wobble, 1/4" Dr, HV Insulated (1057603-00-A) Skt, 1/4" Sq Dr, 13mm, HV Insulated (1057606-00-A) Magnet, Flexible, HV Insulated, 18" (1057607-00-A) Connector Removal, Coolant, PCS, M3 (1

© 2019-2026 Copyright www.tmodel3.com