Tesla Model 3: Subframe Assembly - Rear (Remove and Install)
Tesla Model 3 2017-2026 Service Manual / Chassis / Subframe Assembly - Rear (Remove and Install)
READ NEXT:
Subframe Assembly - Rear - Remove
SPECIAL TOOLS
Kit, EPB Release, Handheld (1134520-00-A)
XP-10 Power Supply, XP-10 (1129348-00-A)
Fixture, Subframe, Model 3 (1099645-00-B)
Lever Lock, HV Connector, Model 3 (1140311-00-A)
Remove
U
Subframe Assembly - Rear - Install
Install
Position the subframe lifting tool and subframe underneath the vehicle.
Connect the air line to the subframe lifting tool.
With an assistant, slowly raise the rear drive unit and subframe
SEE MORE:
Fluid Coupling (55 Degrees) - Rear Drive Unit (Remove and Replace)
SPECIAL TOOLS
Kit, Svc Plug, Cooling Hose, Model 3
(1135762-00-A)
Remove
Remove the mid aero shield panel. See Panel - Aero
Shield - Mid
Trunk (Remove and Replace)
Trunk (Remove and Replace)- Remove
Remove the rear license plate.
Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
Remove the LH and RH rear fog/reverse lights. See Light - Fog / Reverse
- Rear - LH (Remove and Replace).
Remove the trunk exterior release switch. See
© 2019-2026 Copyright www.tmodel3.com
