Tesla Model 3: Chassis
Tesla Model 3 2017-2026 Service Manual / Chassis
- Isolator - Motor Mount - Front - LH (Remove and Replace)
- Subframe Assembly - Front (RWD) (Remove and Install)
- Subframe Assembly - Front (RWD) (Remove and Replace)
- Subframe Assembly - Rear (Remove and Install)
- Subframe Assembly - Rear (Remove and Replace)
READ NEXT:
Isolator - Motor Mount - Front - LH (Remove and Replace)
Remove
Remove the front subframe assembly from the vehicle. See Subframe
Assembly - Front (Dual Motor) (Remove and Install).
Remove and discard the bolts that attach the LH front motor moun
Subframe Assembly - Front (RWD) - Remove
SPECIAL TOOLS
Tool, Axle Extraction, Model 3 (1133386-00-A)
Fixture, Subframe, Model 3 (1099645-00-C)
OTC Lift, 1,650LB Powertrain Table (1066521-00-A)
Lifting Sling, Drive Unit, Model 3 (NA, APAC)
SEE MORE:
Sensor - Radar - Front (Remove and Replace)
Remove
Remove the front fascia. See Fascia - Front (Remove and Install).
Release the clip that attaches the front radar sensor wiring harness to
the front end carrier.
Disconnect the electrical harness connector from the radar sensor.
Release the clips that attach the radar sens
Vent Hose - 12V Battery (Remove and Replace)
Remove
Remove the rear underhood apron. See
Underhood Apron - Rear (Remove and Replace).
Remove the cabin intake duct. See
Duct - Cabin Intake (Remove and Replace).
Remove the hood latch cover. See
Cover - Hood Latch (Remove and Replace).
Remove the underhood storage unit. See
Underhood S
© 2019-2026 Copyright www.tmodel3.com
