Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Trunk (Remove and Install)- Remove

Tesla Model 3 2017-2024 Service Manual / Body / Body Panels / Trunk (Remove and Install) / Trunk (Remove and Install)- Remove

Trunk (Remove and Install)- Remove

Remove

  1. Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).

Trunk (Remove and Install)- Remove

  1. Disconnect the LH and RH rear fog/reverse light electrical connectors.

Trunk (Remove and Install)- Remove

Trunk (Remove and Install)- Remove

  1. Disconnect the rear facing camera electrical connector.

Trunk (Remove and Install)- Remove

  1. Disconnect the trunk exterior release switch electrical connector.

LH shown, RH similar
LH shown, RH similar

  1. Disconnect the LH and RH license plate light electrical connectors.

Trunk (Remove and Install)- Remove

  1. Disconnect the trunk latch electrical connector.

Trunk (Remove and Install)- Remove

  1. Remove and discard the bolts (x2) that attach the trunk harness ground straps to the trunk lid.

Trunk (Remove and Install)- Remove

  1. Release the clips that attach the trunk harness to the trunk lid.

Trunk (Remove and Install)- Remove

  1. Push the trunk harness through the trunk bulkhead and out of the trunk lid.
  2. Use a dry erase marker to mark the position of the trunk hinges on the trunk lid.

RH shown, LH similar
RH shown, LH similar

  1. Remove the bolts that attach the hinges to the trunk lid.
  2. With an assistant, remove the lid from the vehicle, and then place it on a padded surface.

    READ NEXT:

     Trunk (Remove and Install) - Install

    Install With an assistant, position and align the trunk lid to the trunk hinges, and then hand-tighten the bolts that attach the hinges to the trunk lid. Push the trunk harness through the trunk

     Trunk (Remove and Replace)

     Trunk (Remove and Replace)- Remove

    Remove the rear license plate. Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace). Remove the LH and RH rear fog/reverse lights. See Light - Fog / Reverse - Rear - LH (Rem

    SEE MORE:

     Tie Rod End - LH (Remove and Replace)

        Raise and support the vehicle. See Raise Vehicle - 2 Post Lift. Remove the LH front wheel. See Wheel (Remove and Install).

     Foam - Backrest - Driver Seat (Remove and Replace) - Install

    Install Install the driver side airbag into the pocket within the seatback cover. Note: Make sure that the driver side airbag mounting studs extend out of the holes of the pocket. Install the backrest foam down onto the seat back frame, and then install the bottom of the foam into the fram

    © 2019-2024 Copyright www.tmodel3.com