Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Underhood Trim

Tesla Model 3 2017-2026 Service Manual / Exterior Fittings / Underhood Trim

READ NEXT:

 Cover - Shock Tower - LH (Remove and Replace)

Remove Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). Remove the hood latch cove

 Panel - Cowl Screen (Remove and Replace)

Remove Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). Remove the hood latch cove

 Underhood Apron - Rear (Remove and Replace)

Remove Open the hood. Release the clips (x12) that attach the rear underhood apron to the vehicle, and then remove the apron from the vehicle. Install Installation procedure is the

SEE MORE:

 Sensor - Temperature - Evaporator (Remove and Replace)

Remove Remove the driver floormat. Remove the LH center console side panel carpet. See Carpet - Side Panel - Center Console - LH (Remove and Replace). Disconnect the evaporator temperature sensor electrical connector. Release the tabs that attach the evaporator temperature sensor ins

 Mount - Front Drive Unit - LH (Remove and Replace)

Remove Remove the front subframe assembly from the vehicle. See Subframe Assembly - Front (Dual Motor) (Remove and Install). Release the clips that attach the front drive unit harness to the front drive unit inverter. Remove the bolts that attach the LH front drive unit mount to the

© 2019-2026 Copyright www.tmodel3.com