Tesla Model 3: Footrest - Driver (Remove and Replace)
Tesla Model 3 2017-2026 Service Manual / Interior Trim / Pillar and Sill Trim / Footrest - Driver (Remove and Replace)
Remove
- Open the LH front door.
- Move the driver seat fully to the rear.
- Release the clips that attach the driver footrest to the body, and
remove the footrest from the vehicle.
Install
Installation procedure is the reverse of removal.
READ NEXT:
Trim - A-Pillar - Lower - LH (Remove and Replace)
Remove
Open the LH front door.
Remove the LH instrument panel end cap. See
End Cap - Instrument Panel - LH (Remove and Replace).
Remove the LH middle A-Pillar trim panel. See
Trim - A-P
Trim - A-Pillar - Middle - LH (Remove and Replace)
Remove
Remove the LH instrument panel end cap. See
End Cap - Instrument Panel - LH (Remove and Replace).
Release the upper clip that attaches the LH middle A-Pillar trim, and
then pull o
Trim - A-Pillar - Upper - LH (Remove and Replace)
Remove
Open the LH front door.
Remove the LH instrument panel end cap. See
End Cap - Instrument Panel - LH (Remove and Replace).
Remove the LH middle A-Pillar trim. See
Trim - A-Pillar - Midd
SEE MORE:
Link - Lateral - Lower - Front - LH (Remove and Replace)
Remove
Raise and support the vehicle. See
Raise Vehicle - 2 Post Lift.
Remove the LH front wheel. See
Wheel (Remove and Install).
Remove and discard the nut that attaches the LH front lower lateral link
to the knuckle.
Raise the vehicle fully.
Remove the front aero shield. See
Panel
Coolant - HV Battery (Drain and Refill)
SPECIAL TOOLS
Drive Unit Pressure Test Fixture (1053600-00-B)
Adapter, Coolant Reservoir Pressure Test (1130942-00-B)
Kit, Coolant Leak Test Adapters, Model 3 (1132185-00-B)
Kit, Coolant Drain & Fill Adapters, M3 (1133843-00-A)
Kit, Svc Plug, Cooling Hose, Model 3 (1135762-00-A)
Kit, Battery C
© 2019-2026 Copyright www.tmodel3.com
