Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Pillar and Sill Trim

READ NEXT:

 Footrest - Driver (Remove and Replace)

Remove Open the LH front door. Move the driver seat fully to the rear. Release the clips that attach the driver footrest to the body, and remove the footrest from the vehicle. Inst

 Trim - A-Pillar - Lower - LH (Remove and Replace)

Remove Open the LH front door. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace). Remove the LH middle A-Pillar trim panel. See Trim - A-P

 Trim - A-Pillar - Middle - LH (Remove and Replace)

Remove Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace). Release the upper clip that attaches the LH middle A-Pillar trim, and then pull o

SEE MORE:

 Trim - Side Rail - LH (Remove and Replace)

Remove Remove the LH side rail trim. See Trim - Side Rail - LH (Remove and Install). Release the clips that attach the old LH side rail tethers to the LH side rail, and then remove and discard the tethers from the vehicle. Install If not pre-installed, install new push clips (x

 Window Motor / Regulator Assembly - Rear - LH (Remove and Replace)

SPECIAL TOOLS Rivnut Install Kit, for NA (1054712-00-A )Rivnut Install Kit, for EMEA (1054712-01-A ) Service rivnut (1004296-00-A)Service bolt (1015888-00-C) Warning: The side impact airbag deployment depends on the front door sensor's ability to detect a side impact from air pressure. Make sure

© 2019-2026 Copyright www.tmodel3.com