Tesla Model 3: Seal - Glass Run - Front Door - LH (Remove and Replace)- Remove
Remove
- Remove the LH front door trim panel. See
Panel - Door Trim - Front - LH (Remove and Install).
- Remove the LH front door inner belt seal from the door. See
Seal - Inner Belt - Front Door - LH (Remove and Replace).
- Disconnect the mirror electrical harness from the connectors.
- Release the clips that attach the LH front door glass run seal to the LH
front door.
- Remove the bolts that attach the LH door mirror to the LH front door.
Caution:
Use only hand tools to remove or install the fasteners. Do not use
impact or power tools.
- Release the clip that attaches the LH door mirror electrical harness to
the LH front door, and then remove the mirror from the door.
- Pull upwards to remove the LH front door glass run seal from the LH
front door.
READ NEXT:
Install
Position the new LH front door glass run seal on the LH front door.
Tip:
If necessary, apply a small amount of P80 lubricant on the length of the seal to
aid installation.
Remove
Open the hood.
Release the seal from the underhood storage unit, and then remove the
seal from the underhood storage unit.
Install
Installation procedure is the reverse of remov
Remove
Remove the LH front door trim panel. See
Panel - Door Trim - Front - LH (Remove and Replace).
Remove the rear of the inner belt seal from the door.
Release the rest of the seal fro
SEE MORE:
Remove
Remove the LH instrument panel end cap. See
End Cap - Instrument Panel - LH (Remove and Replace).
Release the upper clip that attaches the LH middle A-Pillar trim, and
then pull out the trim to remove it from the vehicle.
Note: Remove any remaining LH middle A-pillar trim clip
Remove
Remove both the LH and RH air wave end caps. See
End Cap - Air Wave - LH (Remove and Replace).
Release the clips that attach the main instrument panel decor trim, and
then remove the trim from the instrument panel.
Install
Installation procedure is the reverse of removal, exc