Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Wipers and Washers

READ NEXT:

 Reservoir - Windshield Washer (Remove and Replace)

Remove Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). Remove the hood latch cover

 Wiper Motor (Remove and Replace)

Wiper Motor- Remove Remove Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). Remove

SEE MORE:

 Brake Rotor - Rear - LH (Remove and Replace)

SPECIAL TOOLS Tool, Caliper Spreader, Model 3 (1134786-00-A) Remove Raise the vehicle and remove the LH rear wheel. See Wheel (Remove and Install). Use Toolbox to place the vehicle into EPB Service Mode. See Release Parking Brake Using Toolbox Disconnect the electrical wiring harness con

 Trim - Side Rail - LH (Remove and Replace)

Remove Remove the LH side rail trim. See Trim - Side Rail - LH (Remove and Install). Release the clips that attach the old LH side rail tethers to the LH side rail, and then remove and discard the tethers from the vehicle. Install If not pre-installed, install new push clips (x

© 2019-2026 Copyright www.tmodel3.com