Tesla Model 3: Audio System - Speakers Subwoofer Amplifier
Tesla Model 3 2017-2024 Service Manual / Infotainment / Audio System - Speakers Subwoofer Amplifier
- Amplifier - Audio - External (Remove and Replace)
- Speaker - Dash - Center (Remove and Replace)
- Speaker - Dash - LH (Remove and Replace)
- Speaker - Emergency (Remove and Replace)
- Speaker - Front Door - LH (Remove and Replace)
- Speaker - Parcel Shelf - LH (Remove and Replace)
- Subwoofer (Remove and Replace)
- Tweeter - Dash (Remove and Replace)
- Tweeter - Front Door - LH (Remove and Replace)
READ NEXT:
Amplifier - Audio - External (Remove and Replace)
Remove
Remove the subwoofer. See Subwoofer (Remove and Replace).
Remove the screws that attach the audio amplifier to the subwoofer
assembly, and remove the amplifier from the subwoofer.
To
Speaker - Dash - Center (Remove and Replace)
Remove
Remove the LH and RH instrument panel end caps. See End Cap - Instrument
Panel - LH (Remove and Replace).
Remove the LH and RH middle A-pillar trims. See Trim - A-Pillar - Middle
- LH
Speaker - Dash - LH (Remove and Replace)
Remove
Remove the LH and RH instrument panel end caps. See End Cap - Instrument
Panel - LH (Remove and Replace).
Remove the LH and RH middle A-pillar trims. See Trim - A-Pillar - Middle
- LH
SEE MORE:
Headlights - Adjust - EMEA (Wall Method)
Adjust Headlights Using a Wall
Apply Tape to Wall
Apply tape to a wall 23.6 in (60 cm) from the ground.
Apply tape to the floor 31.1 ft (9.5 m) from the wall.
Note: EU vehicles require a 1 to 1.5 degree downward inclination in
the headlight beam. For example, a vehicle parked 10 m from the
Bracket - License Plate - Front (EMEA) (Retrofit using Jig)
SPECIAL TOOLS
Front license plate bracket jig, Model 3, EMEA (1496772-00-A )
Procedure
Clean the front center surface of the front fascia with isopropyl
alcohol (IPA) wipe, and then allow surface to dry before continuing.
Put the front license plate bracket on the jig: Line up the 2 hol
© 2019-2024 Copyright www.tmodel3.com
