Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Brake Pad Kit - Rear (Sport Brakes) - Install

Tesla Model 3 2017-2024 Service Manual / Brakes / Brake Discs and Calipers / Brake Pad Kit - Rear (Sport Brakes) (Remove and Replace) / Brake Pad Kit - Rear (Sport Brakes) - Install

Install

  Brake Pad Kit - Rear (Sport Brakes) - Install

  1. Install the brake pad on the LH rear brake caliper bracket.

Tip: During installation, press the brake pad away from the brake rotor.

  Brake Pad Kit - Rear (Sport Brakes) - Install

  1. Install the brake pad on the LH rear brake caliper. Note: Mate the brake pad spring clips to the LH rear caliper cutouts.

  Brake Pad Kit - Rear (Sport Brakes) - Install

  1. Position the LH rear caliper on the LH rear caliper bracket.

  Brake Pad Kit - Rear (Sport Brakes) - Install

  1. Install the lower bolt that attaches the LH rear caliper to the LH rear caliper bracket. Torque 90 Nm

  Brake Pad Kit - Rear (Sport Brakes) - Install

  1. Install the upper bolt that attaches the LH rear caliper to the LH rear caliper bracket. Torque 47.5 Nm

  Brake Pad Kit - Rear (Sport Brakes) - Install

  1. Install the rubber cap that covers the upper LH rear caliper to caliper bracket bolt.
  2. Repeat steps 4 to 6 for the RH rear brake pads.
  3. Install the LH and RH rear wheels. See Wheel (Remove and Install).
  4. Lower the vehicle, and then shift the vehicle into Park.
  5. Pump the brake pedal to seat the pads against the brake rotor until the brake pedal feels firm.
  6. Perform a test drive and burnish the brakes. See Brake Pads - Burnishing.

    READ NEXT:

     Brake Rotor - Front - LH (Remove and Replace)

    SPECIAL TOOLS Tool, Caliper Spreader, Model 3 (1134786-00-A) Remove Raise the vehicle and remove the front LH wheel. See Wheel (Remove and Install). Remove the bolt that attaches the LH fron

     Brake Rotor - Rear - LH (Remove and Replace)

    SPECIAL TOOLS Tool, Caliper Spreader, Model 3 (1134786-00-A) Remove Raise the vehicle and remove the LH rear wheel. See Wheel (Remove and Install). Use Toolbox to place the vehicle into EPB Serv

     Shield - Dust - Brake - Front - LH (Remove and Replace)

    Remove Note: This procedure is applicable to both Model 3 base and sport brake dust shields. Remove the LH front brake rotor. See Brake Rotor - Front - LH (Remove and Replace). Remove the b

    SEE MORE:

     Spoiler - Rear (Retrofit using Tape)

    Procedure Clean the installation surface of the spoiler with isopropyl alcohol (IPA) wipes, and allow it to dry before continuing. Note: Clean any moisture or contaminates that might be present from rain or vehicle washing, otherwise this might result in poor adhesion of the rear spoiler.

     Glass - Door - LH - Front (Adjust)

    DRAFT Warning: This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Do not redistr

    © 2019-2024 Copyright www.tmodel3.com