Tesla Model 3: Brake Discs and Calipers
Tesla Model 3 2017-2026 Service Manual / Brakes / Brake Discs and Calipers
- Brake Caliper - Front - LH (Remove and Replace)
- Brake Caliper - Rear - LH (Remove and Replace)
- Brake Pads - Burnishing
- Brake Pad Kit - Front (Base Brakes) (Remove and Replace)
- Brake Pad Kit - Front (Sport Brakes) (Remove and Replace)
- Brake Pad Kit - Rear (Base Brakes) (Remove and Replace)
- Brake Pad Kit - Rear (Sport Brakes) (Remove and Replace)
- Brake Rotor - Front - LH (Remove and Replace)
- Brake Rotor - Rear - LH (Remove and Replace)
- Shield - Dust - Brake - Front - LH (Remove and Replace)
- Shield - Dust - Brake - Rear - LH (Remove and Replace)
- Shield - Dust - Brake - Rear - LH and RH (Retrofit)
READ NEXT:
Brake Caliper - Front - LH (Remove and Replace)
SPECIAL TOOLS
Skt, 1/2" Dr, E18 Torx
(1133187-00-A)
Skt, 1/2" Dr, E18 Torx
(1133187-XX-A & -01-A)
Remove
Brake Caliper - Rear - LH (Remove and Replace)
Brake Caliper - Rear - LH - Remove
SPECIAL TOOLS
Kit, EPB Release, Handheld (1134520-00-A)
SEE MORE:
Pressure Transducer - Low Pressure (Remove and Replace)
Remove
Recover the A/C refrigerant. See A/C Refrigerant (Recovery and Recharge).
Note: Completely recover the refrigerant before continuing this
procedure.
Disconnect 12V power. See 12V Power (Disconnect and Connect).
Disconnect the electrical connector to the low pressure transducer.
Seal - Hood (Remove and Replace)
Remove
Open the hood.
Release the seal from the underhood storage unit, and then remove the
seal from the underhood storage unit.
Install
Installation procedure is the reverse of removal, except for the following:
During installation, align the line from the seal to the line from the
© 2019-2026 Copyright www.tmodel3.com
