Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Fascia - Front (Remove and Replace)-Install

Tesla Model 3 2017-2023 Service Manual / Body / Bumper / Fascia / Fascia - Front (Remove and Replace) / Fascia - Front (Remove and Replace)-Install

Install

Installation procedure is the reverse of removal.

Top
Top

Bottom
Bottom

  1. Install the front fascia grille onto the front fascia, and then fasten the clips (x9) that attach the grille to the fascia.

Fascia - Front (Remove and Replace)-Install

  1. Install the screws that attach the front fascia grille to the front fascia. Torque 1.8 Nm

Fascia - Front (Remove and Replace)-Install

  1. Install the tow hook cover to the front fascia, and then fasten the clips that attach the cover to the fascia.

Fascia - Front (Remove and Replace)-Install

  1. Install the electrical harness to the front fascia, and then fasten the clips that attach the electrical harness to the fascia.

Fascia - Front (Remove and Replace)-Install

  1. Connect the electrical harness to the ambient air temperature sensor connector.

LH Front Parking Assist Sensor Shown
LH Front Parking Assist Sensor Shown

  1. Install the parking distance sensors (x6) to the front fascia, and then fasten the clips that attach the sensors to the fascia.

LH Front Parking Assist Sensor Shown
LH Front Parking Assist Sensor Shown

  1. Connect the electrical harness to all of the front parking distance sensors connectors (x6).
  2. Install the front turn signal/fog light to the front fascia, and then fasten the tabs (x4) that attach the light to the fascia.

Fascia - Front (Remove and Replace)-Install

  1. Install the screws that attach the front turn signal/fog light to the front fascia. Torque 2.8 Nm

Fascia - Front (Remove and Replace)-Install

  1. Fasten the clips that attach the electrical harness to the front turn signal/fog light.

Fascia - Front (Remove and Replace)-Install

  1. Connect the electrical harness to the RH front turn signal/fog light connector.
  2. Install the front fascia.
  3. Install the front license plate bracket.

    READ NEXT:

     Fascia - Rear (Remove and Install)

    Remove Remove the 2nd row lower seat cushion Remove the trunk sill trim. Remove the LH and RH taillights. On each side of the vehicle, remove the bolt that attaches the corner of the rear

     Fascia - Rear - Lower (Remove and Replace)

    DRAFT Warning: This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements

     Fascia - Rear - Upper (Remove and Replace)

    Remove Remove the rear fascia. Remove all of the rear parking distance sensors. Release the tabs that attach the LH and RH rear reflectors to the rear fascia, and then remove the reflecto

    SEE MORE:

     Closeout Panel - Door - Front - LH (Remove and Install)

    SPECIAL TOOLS Rivnut Install Kit, for NA (Optional special tool if the thread for the closeout panel becomes stripped) (1054712-00-A ) Rivnut Install Kit, for EMEA (Optional special tool if the thread for the closeout panel becomes stripped) (1054712-01-A ) Service Rivnut (Optional special tool

     Windshield (Remove and Replace)- Install

    Install Note: Use soft materials to protect the windshield and to prevent scratching. Place the new windshield on a support stand with the windshield bracket facing up. Install the GPS antenna into the windshield bracket, and then install the screw that attaches the antenna to the bracket

    © 2019-2023 Copyright www.tmodel3.com