Tesla Model 3: Interior Mirror and Sun Visors
Tesla Model 3 2017-2026 Service Manual / Interior Trim / Interior Mirror and Sun Visors
- Check Base - Sun Visor - Driver (Remove and Replace)
- Sun Visor - Driver (Remove and Replace)
- Mirror - Rear View (Remove and Replace)
- Quad Camera Cover - Lower (Remove and Replace)
- Quad Camera Cover - Upper (Remove and Replace)
READ NEXT:
Check Base - Sun Visor - Driver (Remove and Replace)
Remove
Remove the LH instrument panel end cap. See
End Cap - Instrument Panel - LH (Remove and Replace).
Release the clips that attach the LH air wave end cap to the main
instrument panel
Sun Visor - Driver (Remove and Replace)
Remove
Remove the fastener that attaches the driver sun visor to the vehicle.
Torque 6 Nm
Disconnect the electrical connector from the driver sun visor.
Remove the driver sun visor fro
Mirror - Rear View (Remove and Replace)
Remove
Remove the lower quad camera cover. See
Quad Camera Cover - Lower (Remove and Replace).
Grip the rear view mirror stalk, and then turn counterclockwise to
release the rear view mi
SEE MORE:
Seal - Body - Side - Rear - Primary - LH (Remove and Replace)
Remove
Remove the LH B-pillar applique. See
Applique - B-Pillar - LH (Remove and Replace).
Release the clips (x3) that attach the rear LH primary body seal to the
mid B-pillar, the upper B-pillar, and the mid C-pillar.
Pull on the seal to remove it from the body.
Install
Loosely
Seal - Outer Belt - Rear Door - LH (Remove and Replace)
Note:
This procedure was formulated using a release candidate or production
model. Follow safety requirements and use extreme caution when working on or
near high-voltage systems and components.
Remove
Open the LH rear door and lower the window.
Pry the outer belt seal from the rear do
© 2019-2026 Copyright www.tmodel3.com
