Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Keyless Entry and Security

Tesla Model 3 2017-2026 Service Manual / Electrical / Keyless Entry and Security

READ NEXT:

 Antenna - Bluetooth Passive Entry - Front (Remove and Replace)

Remove Raise and support the vehicle. See Raise Vehicle - 2 Post Lift. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct -

 Antenna - Bluetooth Passive Entry - Rear (Remove and Replace)

Remove Remove the rear fascia. See Fascia - Rear (Remove and Install). Disconnect the electrical wiring harness connector from the rear Bluetooth passive entry module. Remove the bolt a

 Key - Programming (With Authenticated Key Present)

Note: Perform this procedure when at least one of authenticated keys are present. Note: The vehicle supports up to 19 keys. When reaching this limit, a key must be deleted before adding a new key. A

SEE MORE:

 Duct - HVAC Plenum - Outer (Remove and Replace)

Remove Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). Release the clips that attach the outer HVAC plenum duct to the inner HVAC plenum duct, and then remove the outer HVAC pl

 Latch - Trunk (Remove and Replace)

Remove Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace). Disconnect the electrical connector from the trunk latch. Remove the bolts that attach the trunk latch to the trunk lid, and then remove the latch from the vehicle. Install Position the trunk lat

© 2019-2026 Copyright www.tmodel3.com