Tesla Model 3: Underhood Storage Unit (Remove and Replace) -
Install
Install
- Install the reinforcement clips that are attached to the underhood
storage unit, if installing a new the underhood storage unit. Otherwise,
skip to the next step if reusing the underhood storage unit.
- Install the clips that attach the underhood storage unit to the vehicle.
Note: Make sure that all clips for the underhood storage unit are
engaged.
- Install the tow hook on the underhood storage unit.
- Install the bolts that attach the underhood storage unit to the vehicle.
Torque 5 Nm
- Install the underhood storage unit carpet.
- Install the hood latch cover. See
Cover - Hood Latch (Remove and Replace).
- Install the cabin intake duct. See
Duct - Cabin Intake (Remove and Replace).
- Install the rear underhood apron. See
Underhood Apron - Rear (Remove and Replace).
READ NEXT:
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements and
Remove the front passenger seat. See
Seat - Driver (Remove and Replace).
Remove the center console. See
Center Console (Remove and Install).
Release the clips that attach the RH front carpe
SEE MORE:
Remove
Remove the LH instrument panel end cap. See
End Cap - Instrument Panel - LH (Remove and Replace).
Remove the LH middle A-pillar trim. See
Trim - A-Pillar - Middle - LH (Remove and Replace).
Remove the LH lower A-pillar trim. See
Trim - A-Pillar - Lower - LH (Remove and Replace).
Rem
Remove
Disconnect 12V power. See
12V Power (Disconnect and Connect).
Remove the center console decor trim. See
Decor Trim - Center Console (Remove and Replace).
Remove the screws and release the tabs that attach LH and RH bright
strips to the center console, and then remove the strips