Tesla Model 3: 12V Battery and Fuses
Tesla Model 3 2017-2026 Service Manual / Electrical / 12V Battery and Fuses
- 12V Power (Disconnect and Connect)
- Battery - 12V (Remove and Replace)
- Beam - 12V Battery (Dual Motor) (Remove and Replace)
- Beam - 12V Battery (RWD) (Remove and Replace)
- Bracket - 12V Battery (Dual Motor) (Remove and Replace)
- Bracket - 12V Battery (RWD) (Remove and Replace)
- Strap - 12V Battery (Remove and Replace)
- Vehicle Electrical Isolation Procedure
- Vent Hose - 12V Battery (Remove and Replace)
READ NEXT:
12V Power (Disconnect and Connect)
12V Power- Disconnect
SPECIAL TOOLS
Cap, Logic Conn, Inv, 3DU (1108272-00-B)
Warning: This procedure disables 12V power, but does not verify that
high voltage power is no longer available to high v
SEE MORE:
Forward Facing (Remove and Replace)
Remove
Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
Release the clips that attach the mirror front cover to the windshield
bracket, and then separate the cover from the bracket.
Disconnect the electrical harness from the occupant camera, and then
remove the
Trim - Sill - Trunk (Remove and Replace)
Remove
Remove the trunk floor trim. See
Trim - Floor - Trunk (Remove and Replace).
Release the clips that attach the trunk sill trim to the body.
Tip: Pull the corner of the trunk sill trim upwards to release the
corner clip, and then release the remaining clips.
Remove the tru
© 2019-2026 Copyright www.tmodel3.com
