Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Luggage Compartment Trim

READ NEXT:

 Cover - Hood Latch (Remove and Replace)

Remove Open the hood. Release the clips that attach the hood latch cover to the body.  Tip: Grab the cover from the bottom, and then pull it upward to release the clips. Disconne

 Switch - Child Safety - Underhood Storage Area (Remove and Replace)

Remove Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace). Release the clips that attach the child safety switch to the hood latch cover, and remove the switch from

 Trim - Floor - Trunk (Remove and Replace)

Remove Open the rear trunk. Lift up the trunk floor trim and remove it from the vehicle. Tip: Use the pull tab located at the rear edge of the trunk floor trim. Install Installation pr

SEE MORE:

 Forward Facing (Target Calibration)

SPECIAL TOOLS Camera Calibration Target (1053066-00-A) Wrench, 2.5mm, Thin (1448868-00-A) Note: This procedure describes how to calibrate the forward facing cameras. It does not apply to the rear facing camera. Setup Park the vehicle on a flat surface with at least 106 cm (3.5 ft) of space in

 Handle - Exterior Release - Door - Rear - LH (Remove and Replace)

Warning: The side impact airbag deployment depends on the front door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the front door shells. Additionally, always reinstall plugs or tape when servicing or inspecting the front doors and t

© 2019-2026 Copyright www.tmodel3.com