Tesla Model 3: HV Battery Enclosure
Tesla Model 3 2017-2026 Service Manual / Battery System / HV Battery Enclosure
- Breathers - HV Battery (Remove and Replace)
- Cover - HV Probe - HV Battery (Remove and Replace)
- Cover - Penthouse (Remove and Replace)
- Flood Ports - 2nd Generation (Remove and Replace)
- Flood Ports - 2nd Generation (Retrofit)
- Gasket - Cover - HV Battery (Remove and Replace)
- HV Battery Air Leak Test
- Penthouse Air Leak Test
- Platter Enclosure Air Leak Test
- Ski - Center Rail - HV Battery (RWD) (Remove and Replace)
- Ski - Center Rail - HV Battery (Dual Motor) (Remove and Replace)
- Skid Plate - HV Battery - Front (Remove and Replace)
- Skid Plate - HV Battery - Rear (Remove and Replace)
- Vent Assembly - HV Battery - LH (Remove and Replace)
- Vent Assembly - HV Battery - RH (Remove and Replace)
READ NEXT:
Breathers - HV Battery (Remove and Replace)
Remove
Remove the mid aero shield panel. See
Panel - Aero Shield - Mid (Remove and Replace).
Release the fir tree clips that attach the coolant hoses to the LH shear
plate.
Remove and d
Cover - HV Probe - HV Battery (Remove and Replace)
Warning:
Only technicians who have been trained in High Voltage Awareness are
permitted to perform this procedure. Proper personal protective equipment (PPE)
and insulating HV gloves with a minimum
Cover - Penthouse (Remove and Replace)
SPECIAL TOOLS
Asy, Service Cover, Penthouse, Model 3 (1127845-00-A)
Skt, 1/4in Dr, 5-Lobe Torx Plus External (1059330-00-B)
Wrench, Torque + Angle, 1/4" Dr (1076971-02-A)
Cap, Logic Conn, Inv, 3DU
SEE MORE:
Collision Avoidance Assist
The following collision avoidance features are
designed to increase the safety of you and
your passengers:
Forward Collision Warning - provides
visual and audible warnings in situations
when Model 3 detects that there is a high
risk of a frontal collision
Automatic Emergency Braking -
Bracket - License Plate - Front (EMEA) (Retrofit using Jig)
SPECIAL TOOLS
Front license plate bracket jig, Model 3, EMEA (1496772-00-A )
Procedure
Clean the front center surface of the front fascia with isopropyl
alcohol (IPA) wipe, and then allow surface to dry before continuing.
Put the front license plate bracket on the jig: Line up the 2 hol
© 2019-2026 Copyright www.tmodel3.com
