Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Harnesses

READ NEXT:

 Busbar - DCDC Ground (Remove and Replace)

Remove Disconnect 12V power. See 12V Power (Disconnect and Connect). Remove and discard the nut that attaches the DCDC ground busbar to the HV battery at the DCDC passthrough. Remove

 Harness - 12V Battery Ground (Remove and Replace)

Harness - 12V Battery Ground-Remove Remove Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace). Remove and discard the nut that attaches the front harness ground wire

SEE MORE:

 Heater - PTC (Remove and Replace)

Heater - PTC- Remove Remove Raise and support the vehicle on a 2 post lift. See Raise Vehicle - 2 Post Lift. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace). Rem

 Module - Restraint Control (Remove and Replace)

Note: This procedure was formulated using a release candidate or production model. Follow safety requirements and use extreme caution when working on or near high-voltage systems and components. Remove Remove the LH and RH center console side panel carpets. See Carpet - Side Panel - Center

© 2019-2026 Copyright www.tmodel3.com