Tesla Model 3: Latches Strikers and Pinch Sensors
Tesla Model 3 2017-2026 Service Manual / Closures / Latches Strikers and Pinch Sensors
- Actuator - Latch - Hood - Primary (Remove and Replace)
- Actuator - Latch - Hood - Secondary (Remove and Replace)
- Latch - Door - Front - LH (Remove and Replace)
- Latch - Door - Rear - LH (Remove and Replace)
- Latch - Hood (Remove and Replace)
- Latch - Trunk (Remove and Replace)
- Manual Release - Door - Rear - LH (Actuate)
- Striker - Door - Front - LH (Remove and Replace)
- Striker - Door - Rear - LH (Remove and Replace)
- Striker - Hood (Remove and Replace)
- Striker - Trunk (Remove and Replace)
- Switch - Exterior Release - Trunk (Remove and Replace)
READ NEXT:
Actuator - Latch - Hood - Primary (Remove and Replace)
Remove
Remove the rear underhood apron. See Underhood Apron - Rear (Remove and
Replace).
Remove the cabin intake duct. See Duct - Cabin Intake (Remove and
Replace).
Remove the hood latch co
Actuator - Latch - Hood - Secondary (Remove and Replace)
Actuator - Latch - Hood - Secondary (Remove and Replace)- Remove
Remove
Remove the rear underhood apron. See Underhood Apron - Rear (Remove and
Replace).
Remove the cabin intake duct. See Duct
SEE MORE:
Key - Programming (With Authenticated Key Present)
Note: Perform this procedure when at least one of authenticated keys
are present.
Note: The vehicle supports up to 19 keys. When reaching this limit,
a key must be deleted before adding a new key.
Adding a New Key Card or Key Fob
Note: If adding a key fob, make sure the key fob is at room
tempera
Hood (Remove and Install)
Remove
Remove the LH and RH hood gas struts. See Gas Strut - Hood - LH (Remove
and Replace).
Use tape to mark the mounting locations of the LH and RH hood hinges on
the hood.
With an assistant, remove the nuts that attach the hood assembly to the
LH and RH hood hinges.
With
© 2019-2026 Copyright www.tmodel3.com
